Page 90 Remove the three Phillips PM2. Equipment guidelines Grounding equipment must include either a wrist strap or a foot strap at a grounded workstation. Reverse this procedure to install the switch cover. Remove all screws that secure the display panel frame to the display panel. To provide proper ground, wear a strap snugly against the skin at all times.

Uploader: Arashigar
Date Added: 17 August 2009
File Size: 24.63 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 64819
Price: Free* [*Free Regsitration Required]

Disconnect the display panel cable 2 and the backlight cable 3 from the display inverter. Improper cable placement can damage the computer. Top cover see Rear cover see Remove the Bluetooth module cable: Refer to the illustration that most closely matches your computer.

The fingerprint reader board is attached to the top cover with double-sided hp 6530b fingerprint sensor.

COMPAQ B – NOTEBOOK PC MAINTENANCE AND SERVICE MANUAL Pdf Download.

Table Of Contents Security menu Disconnect the audio board cable 4 from the system board. Page 45 Spare part Description number Keyboard for use in France Keyboard for use in Italy Keyboard for use in Spain Keyboard for use in Denmark Keyboard for use in Hp 6530b fingerprint sensor Keyboard for use in French Canada Keyboard hp 6530b fingerprint sensor use in Portugal Disconnect the audio board cable 4 from the system board.

Equipment guidelines Grounding equipment must include either a hpp strap or a foot strap at a grounded workstation. The microphone extension cable is included in the Cable Kit, spare part number Remove the switch cover. Revise password policy criteria.

Display assembly see Display assembly on page Top cover see Top cover on page Remove the rear cover: Fingeerprint modem module cable is included in the Cable Kit, spare part number Computer Feet Computer feet The computer feet are adhesive-backed rubber pads.

Lift the right side of the heat sink 1 until it releases from the system board components. Steps 5 through 8 apply only to Hp 6530b fingerprint sensor Compaq b computer models.

Use the computer only on a hard, flat surface. Disconnect the power button board cable 4 from the system board. Heat Sink Remove the heat sink: Sim Connector Board Remove the rear cover 2 hp 6530b fingerprint sensor lifting it straight up.

Turn the display panel upside down. Enter text from picture: There are as many as 94 screws and screw locks, in 15 different sizes, that must be removed, replaced, or loosened when servicing the computer. A discharge of static electricity from a finger or other conductor can destroy static-sensitive devices or microcircuitry. The backlight contains mercury. Remove the 6530 frame from the display panel. Page Top hp 6530b fingerprint sensor see 65330b cover see Remove the Bluetooth hp 6530b fingerprint sensor cable: See steps 5 through 8 for removing the heat sink on HP Compaq b computer models.

Remove the speaker 2 from the base enclosure. Computer Setup This user guide describes features that are common to most models. Remove the top cover.

The WLAN antenna hp 6530b fingerprint sensor are attached to the display enclosure with double-sided tape. See steps 5 hp 6530b fingerprint sensor 8 for removing the heat sink on HP Compaq b computer models. One screw that secures the system board to the base enclosure on computer models not equipped with a WWAN module Chapter 7 Screw listing Display Inverter Display inverter Description Spare hp 6530b fingerprint sensor number For use only 653b0 HP Compaq b computer models For use only with HP Compaq b computer models Before removing the display inverter, sensog these steps: Page When replacing the system board, be sure that the following components are removed from the defective system board and installed on the replacement system board: Your password settings and security settings are not changed when you restore the factory settings.

Remove the backlight cables 1 from the clip 2 in the display panel. Disconnect all display panel cables 1 from the display inverter and remove the inverter 2.

Remove the modem module. Reverse this procedure to install the WWAN module.

HP Compaq 6530b Maintenance And Service Manual

Remove the three Phillips PM2. The Bluetooth module spare part kits do not include a Bluetooth module cable. The feet are included in the Rubber Kit, spare part number System boards include system board bracket, system board, and replacement thermal material: Page 59 Disconnect hp 6530b fingerprint sensor Bluetooth module cable 2 from the Bluetooth module.